|
NOTES:
a: This cable is an AutoDetect version that will
automatically configure itself to the gage parameters, no
configuration necessary. There is also a standard version of the
cable available that needs to be configured.
b: Uses Local CAN with DB9 or DB25.
c: We're sorry - this model has been phased out and
we are no longer able to provide any support.
d: For this model, Ver. 3 firmware card or higher is
required.
e: Command Serial = 48 41 32 35 (HA25 CRLF).
f: Local CAN with DB25.
g: Local CAN with DB9.
h: Turn off handshaking when in printer mode.
i: Not available - 20mA loop - Mettler makes a $600
option to allow output.
j: Command Serial = 50 0D (P<CR>)
|
